Tie-down Xi2 Foundation System Bedienungsanleitung PDF herunterladen

Xi2

Ground System

(For Block)

Xi2

Ground System

(For Steel Pier)

Xi2 Ground System

with Longitudinal Stabilization

(One Longitudinal Strut for Wind Zone I

Two Longitudinal Struts for Wind Zones II & III, [Shown Above])

Instruction #08108

101613,D975

REQUIREMENTS

• Install in any type soil, 4B (175 – 275 lbs.) or better.

• Main Rail spacing must be 75.5” – 99.5”, 112” exception with proper strut.

• Maximum pier height at system is 48”.

• Wind Zones II & III require sidewall anchors for up lift, check manufacturers requirements.

• Maximum vertical projection at sidewall is 9’ (wall and eave). Higher walls may be used when design loads are

adjusted accordingly.

• Longitudinal strut angles need to be no more than 50 degrees and no less than 25 degrees. See page 4.

• The Xi2 ground pad is installed under, and serves as the footer for one of the piers required by the home

manufacturer installations instructions.

• Two systems designed to work in conjunction with each other must be placed as evenly as possible. Measuring

from the center of block/pier on the Ground Pad, systems are to be placed no less than 2’ and no more than 10’

from each end of home. Components of the Xi2 system such as the longitudinal strut and connecting hardware may

extend beyond the pier location. Additional systems per instructions, see page 4.

• For roof slopes greater than 20 degrees, (4.37” in 12” Pitch) see page 4.

• This System only replaces normal lateral frame tie and or longitudinal end tie anchorage. The home manufacturer

may require additional vertical anchor ties that are unique to a home’s design. These locations may include shear

walls, marriage line ridge beam supports, and rim plates. Check the manufacturer’s installation instructions for

set-up requirements.

Xi2 components exceed HUD code 3280.306 g “Anchoring equipment exposed to weathering shall have a resistance to

weather deterioration at least equivalent to that provided by a coating of zinc on steel of not less than 0.30 ounces per

square foot of surface coated.

Ground Foundation System

Installation Instructions for Wind Zone I, II & III

Except Florida and California

By Tie Down Engineering

Updated: 10/16/2013

1 2 3 4

Inhaltsverzeichnis

Seite 1 - Ground Foundation System

Xi2Ground System(For Block)Xi2Ground System(For Steel Pier)Xi2 Ground Systemwith Longitudinal Stabilization(One Longitudinal Strut for Wind Zone ITwo

Seite 2 - Xi2 Lateral Stabilization

Xi2 Lateral StabilizationSingle Section Home0 - 76’ Box 2 Xi2 SystemsOver 76’ Box 3 Xi2 SystemsSingle Section Home0 - 64’ Box 2 Xi2 SystemsOver 64

Seite 3 - Tek Screws

Xi2 Longitudinal Stabilization for Wind Zone I, II & IIISingle SectionUp to 16’ NominalDouble SectionUp to 32’ NominalTriple Sectionup to 48’ No

Seite 4 - Strut Angles:

Kommentare zu diesen Handbüchern

Keine Kommentare

Tie-down Xi2 Foundation System Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Hardware Tie-down Xi2 Foundation System herunter. Tie Down Xi2 Foundation System User Manual [es] [it] [de] [en] Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Tie-down Xi2 Foundation System