Tie-down Vector Dynamics Foundation System for Wind Zones l Bedienungsanleitung PDF herunterladen (Seite 3)

50 in. max.

Figure 1

50 in. max.

24”

26” Maximum

Unequal Pier Heights

Homeswithunequalpierheightsarelimitedto50”maximumpierheight.Thedifferencebetweenthetallerpier

andtheshorterpiercannotexceed26”.

Figure 2

Maximum Pier Height

Vector Dynamics Foundation Systems may be used on single section homes in Wind Zone I which require pier

heights(fromsurfaceofVectorpadstotopofconcreteormetalpier)nottoexceed50inchesunderoneor

bothmainrail(s).NotethatagroundanchormustbeusedateachVectorsystemlocationwherethepierheight

exceeds24inchesforsinglesectionhomes.Onmulti-sectionhomesinWindZoneI,ananchormustbeusedat

eachVectorSystemlocationwithpierheightsabove46”withthefollowingexception:doublesectionhomesthat

are24’wide,inWindZoneI,haveamaximumpierheightwithoutanchorsof38”.Seepage16fordouble

section home high pier set instructions.

3 Revised: 8/19/2008

1 2 3 4 5 6 7 8 ... 23 24

Keine Kommentare

Tie-down Vector Dynamics Foundation System for Wind Zones l Bedienungsanleitung Seite 3