Tie-down Vector Dynamics Foundation System for Wind Zones I Bedienungsanleitung PDF herunterladen (Seite 9)

Long U-Bolts

Page 9 4/3/2013

Set-Up Instructions for

Vector System #59018

1. Set Vector Pads

Clear all vegetation where pads will rest. Place a long

U-boltinpadasshown.Pressorhammerpadintothe

ground.

2. Set Block or piers on pads.

Center foundation blocks or piers on pads. Place

pre-cut center compression member between blocks,

restingonpads,centersbetweenU-boltsasshown.

3. Outside Tension Bracket

Attachoutsidetensionbracketasshowntooutside

of pads.

4. Inside brackets & straps

AttachtheinsidetiebracketstotheU-boltsoverthe

compressionmember.Attachastrapw/hookorswivel

strap w/nut & bolt. Place other end of the strap over

opposite I-beam & down to outside tension bracket.

Cutstrap12-15inchespastbracket.Attachstrap

& slotted bolt in bracket. Tighten strap until tight with

4-5wrapsaroundbolt.Repeatwithoppositestrap.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 18 19

Keine Kommentare

Tie-down Vector Dynamics Foundation System for Wind Zones I Bedienungsanleitung Seite 9